MPEG LA MPEG4 Manuel d'utilisateur télécharger pdf (Page 21)

ADVANCED MENU

~17~

4) LS (Level of Sensitivity)

“LS” is to set the sensitivity of comparing two different images. The smaller the value is, the higher sensitivity for

motion detection. The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The default value is 07.

5) SS (Spatial Sensitivity)

“SS” is to set the sensitivity for detecting the size of one object (the number of the grids) on the screen. The

smaller the value is, the higher sensitivity for motion detection.

The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The default setting is 03.

Note: The default setting of SS is 03, which means once an object is detected more than 3 grids, the

system will get triggered. So the value of SS must be less than the number of grids that you set

up for the motion detection area.

6) TS (Time of Sensitivity)

“TS” is to set the sensitivity regarding how long one object stays in the detection area and triggers the recording.

The smaller the value is, the higher sensitivity for motion detection.

The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The default setting is 02.

7) RE (Reference)

“RE” is to set a reference for detection. The default value is 10, which means the DVR will compare 10 continuous

images at one time according to the sensitivity of LS, SS, TS simultaneously.

The bigger the value is, the higher sensitivity for motion detection. The highest sensitivity is 61.

(2) Detection Timer

Move the cursor to “DETECTION TIMER”, and press ”ENTER”. You will see a similar screen as the following:

DETECTION DETECTION TIMER

DETECTION SETUP DATE START END

DETECTION TIMER

OFF 00 : 00

00 : 00

DAILY 08 : 00

18 : 00

SUN 06 : 00

23 : 00

MON-FRI 18 : 00

23 : 00

OFF 00 : 00

00 : 00

OFF 00 : 00

00 : 00

OFF 00 : 00

00 : 00

Set the date, start time and end time for the detection function. The setting method is similar to “TIMER”.

Press “ENTER” to

confirm the start area.

Press “LEFT” or “RIGHT” to

choose the width of the area

Press “UP” or “DOWN” to choose

the height of the area, and press

“ENTER” again to confirm.

You can also up set up

multi-detection areas.

Press “－” to set the whole

area under detection

Press “＋” to set the whole

area undetected

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

MPEG LA MPEG4 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Enregistreurs vidéo numériques (DVR) MPEG LA MPEG4